Unitree Robotics
  • Introduction
    • Safety First
    • Go1 EDU Parts List
    • Getting Started
      • Go1 Standing Pose
      • Installing Battery
      • Powering the Controller
      • Powering On Go1
      • Powering Off Go1
      • Go1 Storage
    • Remote Control
      • Basic Movement
      • Running Mode
      • Standing Actions
      • Stair Climbing Mode
      • Joints Mode
      • Calibration
  • Learning
    • Go1 System Architecture
    • Hardware
      • Raspberry Pi
      • Jetson Nano 1
      • Jetson Nano 2
      • Jetson Nano 3
    • Firmware Update
    • Unitree App
    • Label/Tag
    • Ports
  • Programming
    • Simulation
    • Rack Assembly
    • High Level Control
    • Low Level Control
    • ROS
    • C++
    • Python
  • Resources
Powered by GitBook
On this page
  1. Introduction
  2. Getting Started

Go1 Storage

PreviousPowering Off Go1NextRemote Control

Last updated 2 years ago

Your Go1 kit will come with a stand that can be easily assembled. The video below covers the details but please make sure to use caution when lifting Go1. The robot is fairly heavy and its not always easy to get the pegs of the stand to match up with the receiving holes in Go1's torso.

Unitree Go1 stand assembly video
Assembled Go1 stand
Go1 mounted on stand
Go1 on stand with legs posed