Unitree Robotics
  • Introduction
    • Safety First
    • Go1 EDU Parts List
    • Getting Started
      • Go1 Standing Pose
      • Installing Battery
      • Powering the Controller
      • Powering On Go1
      • Powering Off Go1
      • Go1 Storage
    • Remote Control
      • Basic Movement
      • Running Mode
      • Standing Actions
      • Stair Climbing Mode
      • Joints Mode
      • Calibration
  • Learning
    • Go1 System Architecture
    • Hardware
      • Raspberry Pi
      • Jetson Nano 1
      • Jetson Nano 2
      • Jetson Nano 3
    • Firmware Update
    • Unitree App
    • Label/Tag
    • Ports
  • Programming
    • Simulation
    • Rack Assembly
    • High Level Control
    • Low Level Control
    • ROS
    • C++
    • Python
  • Resources
Powered by GitBook
On this page
  1. Introduction
  2. Getting Started

Installing Battery

PreviousGo1 Standing PoseNextPowering the Controller

Last updated 2 years ago

Before bringing your Go1 to a standing pose we encourage you to understand the battery charging process. The video below demonstrates how to charge and install your battery into the Go1 robot dog.

Go1 battery installation before standing