Unitree Robotics
  • Introduction
    • Safety First
    • Go1 EDU Parts List
    • Getting Started
      • Go1 Standing Pose
      • Installing Battery
      • Powering the Controller
      • Powering On Go1
      • Powering Off Go1
      • Go1 Storage
    • Remote Control
      • Basic Movement
      • Running Mode
      • Standing Actions
      • Stair Climbing Mode
      • Joints Mode
      • Calibration
  • Learning
    • Go1 System Architecture
    • Hardware
      • Raspberry Pi
      • Jetson Nano 1
      • Jetson Nano 2
      • Jetson Nano 3
    • Firmware Update
    • Unitree App
    • Label/Tag
    • Ports
  • Programming
    • Simulation
    • Rack Assembly
    • High Level Control
    • Low Level Control
    • ROS
    • C++
    • Python
  • Resources
Powered by GitBook
On this page
  1. Introduction
  2. Remote Control

Standing Actions

PreviousRunning ModeNextStair Climbing Mode

Last updated 2 years ago

Go1 ships with several different pre-programmed movements called "Standing Actions". Some of these include begging, dancing, and rolling over. The button sequences are listed on the wireless remote controller and can be seen in the video below.

Go1 begging, dancing, and rolling over